Type	1T16BL1	flat overlay, non tactile
Type	1TF16BL1	embossed keys, soft touch

Two colours' graphic layer: black the ground and text,
transparent, transparent red or transparent green the keys' ground.

Rear silk-screened on antiscratching polyester.

Other colours or customized graphic by request.

All keyboard layers are laser cut.

Circuit, spacer, and tail cover: polyester.

Rear adhesive layer: 3M468.

Tracks' material: silver.    Contacts' material: indium oxide.

Connector: female, 8 ways on 2.54mm pitch.

Embossing on type 1TF: Ø 11 mm round, 0.5 mm thick.


The contact resistance is very high:
over 20 kohms with a pressure of 500 grams on button,
so this indium-oxide-contact keyboards, can be used only
on high impedance circuits or interfacing the keyboard
by an operational amplifier.


Apply the keyboard on a transparent, not brittle material
(polycarbonate is the best) at last 3-4 mm thick,
according the size of your panel.
If the panel is painted or coated, please reserve a minimum
transparent squared zone of 60 x 60 mm under the keyboard.


Stick your keyboard on a smooth and clean surface.
Don't trap air bubbles when mounting.

printable page (PDF)

customize your keyboard! (CDR)

this keyboard (framed) can be assembled with Okw A0612007 enclosure too